Product code Product picture  Product full name and installation
Pentax -Flip up 

Pentax Flip up 

  • Line up the 2 holes on the mount with the2holes on the crossbar (flip-up) or frame. 
  • Grey Linkage Arm facing forward.
  • Thread the screws through the holes and then tighten them down. 
  • Done. 
Pentax -TTL

 Pentax TTL mount

  • Using 2 screws going through the slot on the top of the cross bar. 
  • Tighten them down. 
  • Done. 
  •  

 

Reference loupe models to the connectors

Connector product codes
References Loupe models (Note: there may differ due to the hardware development)
Pentax -Flip up 
Pentax -TTL