Product code  Product picture  Product full name and installation
ORA-TTL-2 Holes

Orascoptic TTL - all frames w 2-hole 8mm mount (Installation in PDF)

  • Remove cover from mounting plate on your loupes.
  • With the grey linkage arm oriented on top, place the mount over the 2 screw holes on your frame.
  • Tighten screws down.
  • Done!
ORA-Flip up - GEM

Orascoptic Flip-up mount GEM / Medium (Note: the flip-up mounts are available in different sizes, such as micro/small/medium)

  • Ensure the grey Linkage Arm is oriented on top.
  • Slide mount onto crossbar.
  • Done!
ORA-TTL-XV1

Orascoptic TTL XV1 U-bracket mount

  • Back out the set screw until it is flush with the inside of the mount.
  • Slide the nose bridge (frame) into the opening of the U-bracket mount.
  • Tighten down set screw once mount is in place.
  • Done!
ORA-ErgoEdge

Orascoptic ErgoEdge Sport 

  • Remove cover from mounting plate on your loupes.
  • With the grey linkage arm oriented on top, place the mount over the 2 screw holes on your frame.
  • Tighten screws down.
  • Done!

 

Reference loupe models to the connectors

Connector product codes
References Loupe models (Note: there may differ due to the hardware development)
ORA-TTL-2 Holes

Rydon

Victory Titanium

Revolution

ORA-Flip up - GEM

GEM Small Flip-Up

Square Crossbar Medium Flip-Up

 

ORA-TTL-XV1

Standard01/02 Titanium

Legend

image2016-5-2 14_4_34

Rave

Orascoptic TTLS2

ORA-ErgoEdge

Orascoptic ErgoEdge