Product code Product picture  Product full name and installation
EV-TTL-2 holes

EV TTL 2 Rear Holes mount 

  • Remove screws from the mount.
  • With the grey Linkage Arm down, line up the holes on the mount with the holes on the frame.
  • Insert screws upwards (from below mount) through the holes on the frame and into the mount.
  • Tighten down. Done!

 

Reference loupe models to the connectors

Connector product codes
References Loupe models (Note: there may differ due to the hardware development)
EV-TTL-2 holes

Exam Vision TTL