Product code  Product picture  Product full name and installation
DFV-TTL-Yeoman SUR-TTL-HalfJacket-png Design for Vision Buddy Holly /Yeoman U-Bracket
  •  Back out the set screw until it is flush with the inside of the mount.
  • Slide the nose bridge (frame) into the opening of the U-bracket mount.
  • Tighten down set screw once mount is in place.
  • Done!
DFV-DVI-Sport

Design for Vision DVI Sport & DVI Sport S T-mount

  • Remove T-bracket from T-mount.
  • Remove screws from T-bracket.
  • Insert T-bracket into the hole on the nose bridge of your frame.
  • From the back of the nose bridge, thread the screws through the frame and back into the T-bracket.
  • Tighten down screws until T-bracket is secure.
  • Slide T-mount down over T-bracket.
  • Done!
DFV-Skyview

Design for Vision Sky View

  • Ensure the grey Linkage Arm is oriented on top.
  • Slide the nose bridge (frame) into the opening of the U-bracket mount.
  • Done!
DFV-NIKE-Skylon Design for Vision NIKE Skylon ACE
  • Remove T-bracket from T-mount.
  • Remove screws from T-bracket.
  • Insert T-bracket into the hole on the nose bridge of your frame.
  • From the back of the nose bridge, thread the screws through the frame and back into the T-bracket.
  • Tighten down screws until T-bracket is secure.
  • Slide T-mount down over T-bracket.
  • Done!
DFV-NIKE-Run

Design for Vision NIKE RUN

  • Ensure the grey Linkage Arm is oriented on top.
  • Slide the nose bridge (frame) into the opening of the U-bracket mount.
  • Done!
DFV-NIKE-Curfew

Design for Vision NIKE Curfew Block mount

  • Remove screw from mount.
  • Ensure the silver washer and one black washer are on the screw.
  • Insert screw (with washer on it) into the gap in the back of the nose bridge on your frame.
  • Thread screw into mount. Mount should be on the front of your frame.
  • Tighten down screw.
  • Done!
DFV-TITANIUM-062

Design for Vision TTL TITANIUM 062 mount (Instruction in PDF)

  • Detach mounting plate from mount.
  • Place the mounting plate on the inside of the frame on the nose bridge.
  • Place mount on the outside of the frame. Thread the screw from the mounting plate into the mount.
  • Tighten screw.
  •  Done!

 

Reference loupe models to the connectors

Connector product codes References Loupe models (Note: there may differ due to the hardware development)
DFV-TTL-Yeoman

Buddy Holly /Yeoman U-Bracket

DFV-DVI-Sport

DVI Sport

DVI Sport S

DFV-Skyview

Sky View

DFV-NIKE-Skylon

Nike Skylon Ace

DFV-NIKE-Run

NIKE Run

RUN

NIKE RunX2s

Black

DFV-NIKE-Curfew

NIKE Curfew Modified P1 -Round

DFV-TITANIUM-062

Titanium 062